Scooterotica

Had these on backburner for over 2 years finaly had time to get into production .

I like the hub but not the "blingy" disc. Does that type of disc work better than a conventional round design?

i know a rather nice grp 6 race bike that would look cool with one of them ..want it testing

RICSPEED wrote:i know a rather nice grp 6 race bike that would look cool with one of them ..want it testing

On the beg again,can't fault ya this time tho'

As always Frank a quality bit of kit from you and the PM boys, How much these going to retail at Frank.

corrado wrote:I like the hub but not the "blingy" disc. Does that type of disc work better than a conventional round design?

it will in all honesty shred ya pads fast as fook ... but will stop on the dot

That looks superb. Great bit of work.

only difference at a glance is the centerpiece and anti dive

Now that I Like!!!

Can the centre/hub be supplied powder coated or any reason why this couldn't be done once purchased? Looking to fit to a 60s race style bike and ideally want it white to mimic a standard disc....

Rich wrote:Now that I Like!!!

Can the centre/hub be supplied powder coated or any reason why this couldn't be done once purchased? Looking to fit to a 60s race style bike and ideally want it white to mimic a standard disc....

i would say yes ....but .. surfaces where two parts meet would need masking just as you would for a case for instance