Scooterotica

Hi anyone know what type of aluminium is needed for a weld on cylinder packer and half liner as im looking to do a long stroke ts1.
cheers

pro-circuit wrote:Hi anyone know what type of aluminium is needed for a weld on cylinder packer and half liner as im looking to do a long stroke ts1.
cheers

In the past I have used rods with 17% silicon content when puting in half liners & extending the gasket faces, but to be sure have a word with Langcourts in Weston Super Mare as the repair damaged alloy cylinders proir to replating.
Tel: 01934 612226

Ian Frankland
Taffspeed
07794 003276

Thanks for the reply Ian, would I need to buy a particular grade aluminium to make the packer and liner from as I was thinking of removing top of barrel above exhaust port and make wider fins with extra length for the stroke.

cheers