Calling all LD experts

[skootaloon]

Hi all LD fans,

I have managed to butcher the needle roller bearing that sits in the torsion bar link to the engine. It is on the end of the engine link that fixes on to the frame itself. I have measured the pin that goes through the bearing and have measured the the bore of the link, but they seem to be odd sizes. I don't think a standard "off the shelf" bearing would do the job.
Does anyone know where I can get a new one?


Many thanks


Simon

[ABC]

in the process of rebuilding a 57 ld engine with a varitronc and new crank and scootopia do a bronze bush to replace the bearings in the torsion bar