Scooterotica

Can this be machined to fit a Lammy barrel?

http://www.ebay.co.uk/itm/Cylinder-head ... 4aae6f4ef5

why not just buy the mbd one, by the time thats been imported and machined you ve not saved much money

http://lambrettaspares.com/spareparts/m ... 0241k.html

what he said.......... i have looked at doing this myself and it just isnt worth it unless you can get the head for peanuts

You know it'll be a qaulity bit of kit, but can't stretch to £183.96. Was hoping the head in the link was about right and then off to Rufforth bike jumble tomorrow looking for something cheap.

mawso wrote:You know it'll be a qaulity bit of kit, but can't stretch to £183.96. Was hoping the head in the link was about right and then off to Rufforth bike jumble tomorrow looking for something cheap.

right any head will do as longs as

a - the plug is dead centre

b - the diameter of the chambre is some thing close to what you want

i do know some one who could do the mod

id look for dt250 or sim

What about stud hole positions?

I'll have a look tomorrow for a dirty unloved lump of alu for peanuts then hehe!

mawso wrote:What about stud hole positions?

if you want a head that fits strait on use a lammy one

Porcupine head looks the biz!