Page 1 of 1
Fan Cowls - fed up with the shite ones on offer.
Posted: Sat Oct 22, 2011 7:07 pm
by jimmo
Right, What are the best quality fan cowls on the market? I'm fed up with getting shite cowls that split after 5 miles and don't fit.
Where should I be looking to purchase a quality cowl? Are Mb's Carbon ones any good?
:wtf: :wtf: :wtf:
Re: Fan Cowls - fed up with the shite ones on offer.
Posted: Sat Oct 22, 2011 7:42 pm
by DaveTomo
don't know about carbon,using 1 of these and with the rubber bungs its been fine
http://www.scooterrestorations.com/lamb ... eel-cover/
Re: Fan Cowls - fed up with the shite ones on offer.
Posted: Sat Oct 22, 2011 8:05 pm
by essexgp
Got a original SIL one on my GP and a Serveta one on my cutdown, both were second hand when I got them and they are still in one piece and looking good.
The one I bought new from evilbay is sitting on the shelf in my garage unused, poor fit, poor quality and has got edges like a razor.
Get a good second hand one thats my advice
Re: Fan Cowls - fed up with the shite ones on offer.
Posted: Sat Oct 22, 2011 9:09 pm
by Special X
Won't a genuine Sil cowl be too wide?
Fan Cowls - fed up with the shite ones on offer.
Posted: Sat Oct 22, 2011 9:26 pm
by soulsurfer
jimmo wrote: Are Mb's Carbon ones any good?
:wtf: :wtf: :wtf:
Possibly, but the PM carbon ones tend to split and crack around the bolt holes as they are removed and refitted a few times, also where would you get an MB one?
Re: Fan Cowls - fed up with the shite ones on offer.
Posted: Sun Oct 23, 2011 7:12 pm
by essexgp
Special X wrote:Won't a genuine Sil cowl be too wide?
Mines not, it came on my 1985 SIL Vijay Super Mk2 and is the same width as an Italian one