Page 1 of 1
SIL Crank with Japanese big end bearing
Posted: Sat Sep 03, 2011 7:15 am
by Special X
Has anybody used one of these? How much power will they take.
Re: SIL Crank with Japanese big end bearing
Posted: Sat Sep 03, 2011 10:11 am
by TS1-200
About the same power as a standard Indie crank, but should last much longer,
Re: SIL Crank with Japanese big end bearing
Posted: Sat Sep 03, 2011 11:06 am
by nuttyboy
have one sat in garage done 400 miles .gona put on ebay.?
Re: SIL Crank with Japanese big end bearing
Posted: Sun Sep 04, 2011 12:17 am
by corrado
It'd be interesting to know exactly what bearing is used in these. I've had some Yam rods and bearings fitted to SIL cranks and the bearing fitted to the 115 rod was far cheaper than the RG500 bearing fitted to the 110 rod.