I needs to be the Grimeca / Yamaha type fitting (the inline holes) like in MB picture below
or can you buy these already made
can one of you guys make / weld me a clutch housing up
-
caspa2006
- registered user
- Posts: 186
- Joined: Fri Sep 11, 2009 2:23 pm
- Location: Stourbridge, West Midalnds........ Modern World SC
- Contact:
what I am looking for is a hydraulic clutch housing made to fit indian drops
I needs to be the Grimeca / Yamaha type fitting (the inline holes) like in MB picture below
or can you buy these already made
I needs to be the Grimeca / Yamaha type fitting (the inline holes) like in MB picture below
or can you buy these already made
Vespa made in Italy thrashed in Great Britain
if you know an ally welder some people weld a lever straight to the housing
Its in bits scooter club: www.facebook.com/groups/132415046859320
I can sort it no problem !caspa2006 wrote:what I am looking for is a hydraulic clutch housing made to fit indian drops
I needs to be the Grimeca / Yamaha type fitting (the inline holes) like in MB picture below
or can you buy these already made
-
caspa2006
- registered user
- Posts: 186
- Joined: Fri Sep 11, 2009 2:23 pm
- Location: Stourbridge, West Midalnds........ Modern World SC
- Contact:
cheers mate pm me with your address and i will put the clutch master in the post
i do not have a clutch lever housing can you sort one or shall i get one for you
i do not have a clutch lever housing can you sort one or shall i get one for you
Vespa made in Italy thrashed in Great Britain