I want to trim my legshields.. any tips on how to do it?

[Supereibar]

I have a set of series 2 legshields that are pretty bad and I thought I would trim them up and round them a bit on the edge to give a sporty look to the bike. Any tips? how could I make it so its symetrical?

Best,

J.

[RICSPEED]

grinder ,1mm discs ,flap wheel discs and patience ,cover in masking tape and sketch till it looks right then make a card template and flip over and mark the other side ....i tend to judge by eye ,just take your time

[GBCS]

I would use a nibbler to do the trimming.
Using a grinder on sheet metal is a little bit "OCC" for me, not to mention dangerous

[sean brady scooters]

i always use an electric jigsaw ...

[WINTERMODEL150]

I use a snap on air saw the same one i use to cut car panels up,

[Tooty67]

I plan on doing similar to my (also badly damaged) S2 legshields and plan on trying to blow up a picture of a set of API legshields to use as a template to get them a bit rounder

[rondon]

I usually use a stihl saw & just blast the feck out of stuff, 9times out of 10 turns out just how I expected