Scooterotica

got a 30mm PHBH carb and lth manifold on my ts1

sick to death of getting loads of s***e all over my bodywork

is there a smaller body carb that i can use with a filter/bellows style set up so it doesnt spit fuel/oil everywhere?

cheers
mick

Is there something else wrong with it? I run an open 30mil on mine. Admittedly, it's not dry on the inside of the panel. But it's not exactly dripping fuel everywhere.

Muttley McLadd wrote:Is there something else wrong with it? I run an open 30mil on mine. Admittedly, it's not dry on the inside of the panel. But it's not exactly dripping fuel everywhere.

what main jet you running?

cheers
mick

Jimmers / LTH manifold with Mikuni TMX30 should give you enough clearance to use a breath Sweet filter.

corrado wrote:Jimmers / LTH manifold with Mikuni TMX30 should give you enough clearance to use a breath Sweet filter.

thanks for the info martin

thought so - will be back to jetting again

corrado wrote:Jimmers / LTH manifold with Mikuni TMX30 should give you enough clearance to use a breath Sweet filter.

Just remembered that the TMX 32 & 35s are 6mm thinner than the TMX 30. Hence more clearance.

Mick its throwing fuel out because its overjetted. I've jetted quite a few TS1s with 30mm PHBH and none run anywhere near what your running.

would agree with jetting Ive got two ts1 engines with 34mm dellortos and yes there is some ptrol on panels but nothing like dripping

best of luck

I have mentioned them before
http://www.lectronfuelsystems.com/
anyone using one yet