Scooterotica

Anyone point me in the right direction for the 2 little black screws that hold down the top of a scootsrs master? The brake had developed a spongy feel and is losing bite. I think it might be a leak and this will mean having to bleed it. as the screws i have are made of cheese i know ill never get them back on. Ideally some high tensile ones would be great as these seem to be a use once and chuck away......

Ta
sef

the top of a master cylinder needs to be vented in the same way a petrol cap is

RICSPEED wrote:the top of a master cylinder needs to be vented in the same way a petrol cap is

We are talking about the black plate that sits on top next to the leaver? if so, i didnt think that was vented..

I thought this was going to be about something else

...how refreshing

soulsurfer wrote:I thought this was going to be about something else

...how refreshing

Looked at your comment and thought....errr

then read my subject and it all fell into place....

sydduckett wrote:

soulsurfer wrote:I thought this was going to be about something else

...how refreshing

Looked at your comment and thought....errr

then read my subject and it all fell into place....

anyone know the size & pitch of these screws and where you can get them?

ta

Have you thought about local bike shop.

leigh wrote:Have you thought about local bike shop.

I imagine that thes screws are quite easy to get once you know what they are. I had brought some spares before and thought ill put these away safe for when i next need to open up the master...all smugly..

F**k me, can i find em... Iv had the garage upside down looking. I cant take the ones out because if i do then ill have no brake until i get the spares....Catch 22 and all that....

I believe they're M4

soulsurfer wrote:I believe they're M4

yes they are
http://cgi.ebay.co.uk/cr-f-kx-f-yz-f-rm ... 500wt_1156