Page 1 of 1
EGT boss needed?
Posted: Thu Jan 13, 2011 8:49 am
by wax
I am changing my pipe for one of them new TS1 Pipedesign Bullet jobbies, but i need a new egt boss to weld onto it. Its just a hexagonal lump of metal with a threaded hole down the middle. I have had a look on tinternet but cannot find one anywhere? Any help would be appreciated. Mine is the digital type sold by Cambridge Lambretta
Re: EGT boss needed?
Posted: Thu Jan 13, 2011 10:16 am
by red ghost
Mate, I can help, but I live in Australia, if you're prepared to pay for postage..
Here's one I made for myself;
Re: EGT boss needed?
Posted: Thu Jan 13, 2011 10:22 am
by wax
Mine looks slightly different to that i think. Its a koso type like this one:
http://www.bikebandit.com/koso-motorcyc ... id=1484958
Re: EGT boss needed?
Posted: Thu Jan 13, 2011 10:53 am
by red ghost
Off the top of my head, it is a 1/8th NPT thread, whether it's in round or hex bar that matters not.
Re: EGT boss needed?
Posted: Thu Jan 13, 2011 11:26 am
by wax
Good point Red. Is yours a Koso type?
Re: EGT boss needed?
Posted: Thu Jan 13, 2011 4:00 pm
by wax
I have sent an email the the yanks, but have not had a reply. There must be a UK stockist..........?
Re: EGT boss needed?
Posted: Thu Jan 13, 2011 8:29 pm
by carlos fandango
MB are koso/ stage six stockists