got a scoot rs outboard set up speedo drive looks perfect however when i connect speedo cable to mini speedo i carnt get it to work?
is there different hieghts of the timny clamps on inners?
by that i mean it looks like the tip of my inner is just not quite long enough
speedo cable?????
-
wack 63
- registered user
- Posts: 1254
- Joined: Fri Nov 27, 2009 9:33 pm
- Main scooter: '71 GP TS1
- Location: Lincs
- Contact:
I use a long nail that I filed into a square on the end and push it into the speedo drive then spin the wheel.If it turns ok then I know the problem is with the cable which may need the outer shortening and some of the sleeving trimming back.If the nail doesn't turn then the drive could be tight,unscrewing the outer holder on the hub sometimes lets the drive worm turn.Also seen the worm square too big to grip the inner.
-
C*NTSPEED
- registered user
- Posts: 395
- Joined: Wed Jan 07, 2009 11:44 am
- Main scooter: vespa ts 125/200
- Location: manchesto's beruit
- Contact:
wack 63 wrote:I use a long nail that I filed into a square on the end and push it into the speedo drive then spin the wheel.If it turns ok then I know the problem is with the cable which may need the outer shortening and some of the sleeving trimming back.If the nail doesn't turn then the drive could be tight,unscrewing the outer holder on the hub sometimes lets the drive worm turn.Also seen the worm square too big to grip the inner.
ta very muchy
GEMINI S.C.
BLACK WIDDA'S S.C.
BLACK WIDDA'S S.C.