Scooterotica

whilst i have engine out thought i would change mounts are the indian ones still the better ones on the market where do you all get them from,also i have nice shiny powder coated casings heating with blow tourch wont do them any good i presume any other ways of heating is it a no no to try with them cold i do have the correct puller just always put heat in to them first

Iv'e never pulled in a pair of engine mounts cold , but if i had too I would heat the case with hot water and grease the mounts prior to pulling them in. Im not saying this is the best or only way, just what I would try. I would also wet and dry with fine grade, the engine mounts prior to greasing them to remove any high spots from the original machining... All the best

i just warm the motor with a heat gun and freeze the mounts if thats any help

thanks for that wheres best to get them from at the moment ,are indian mounts any good,heard casa were not all that