Page 1 of 2
Mugello V4 small block, Mikuni TM24
Posted: Fri Oct 22, 2010 12:45 pm
by red ghost
Can anyone offer a starting point for jetting?
cheers
Re: Mugello V4 small block, Mikuni TM24
Posted: Fri Jan 28, 2011 10:52 am
by red ghost
Bump
Re: Mugello V4 small block, Mikuni TM24
Posted: Fri Jan 28, 2011 11:18 am
by Craig H
?
Re: Mugello V4 small block, Mikuni TM24
Posted: Sun Jan 30, 2011 9:40 pm
by paul lester
red ghost wrote:Can anyone offer a starting point for jetting?
cheers
hi i have a mugello v5 i think the latest one with a tm24 and i have a 175 open carb in mine dyno at jahspeed not sure on the clip position the needle was the one that came with it
send me a email address and i will send you a copy of the dyno if you want
Re: Mugello V4 small block, Mikuni TM24
Posted: Sun Jan 30, 2011 10:25 pm
by Craig H
Hi
What gearing you using and what pipe?
Re: Mugello V4 small block, Mikuni TM24
Posted: Sun Jan 30, 2011 10:41 pm
by paul lester
Craig H wrote:Hi
What gearing you using and what pipe?
indian gp 200 standard sprockets 47x18 JL3
Re: Mugello V4 small block, Mikuni TM24
Posted: Sun Jan 30, 2011 10:57 pm
by Craig H
Cheers same here running a filter with a 170 main
Re: Mugello V4 small block, Mikuni TM24
Posted: Sun Jan 30, 2011 11:43 pm
by paul lester
Craig H wrote:Cheers same here running a filter with a 170 main
i tried a filter on mine with a 175 main and it was too rich
mine is a bit juddery driving slow will have to play a bit more thanks
Re: Mugello V4 small block, Mikuni TM24
Posted: Mon Jan 31, 2011 9:33 am
by Craig H
I use a 15 pilot in mine ok low down and second clip down from top. What bhp and torque did yours make? Mine was 16 bhp 12-13 torque
Re: Mugello V4 small block, Mikuni TM24
Posted: Mon Jan 31, 2011 7:08 pm
by paul lester
Craig H wrote:I use a 15 pilot in mine ok low down and second clip down from top. What bhp and torque did yours make? Mine was 16 bhp 12-13 torque
16.59@6988 rpm torque 12.9 @6657 rpm