Scooterotica

Hi All..

Before I plow through all the dealer sites looking for a oval exhaust stub for a Taffy pipe, can anyone point me in the right direction? I'm thinking of putting my TS1 down to a iron MBD tuned barrel.

Little help?

I'm going to rebuild my motor and I'm thinking I want to get MPG over MPH.

Thanks in advance.

The JL manifolds will fit the Taffy pipe if that helps and why not just detune your TS1 ie machine the base down to lower port timings and maybe fit a smaller carb?

Thanks for the reply. I was wondering if there was an answer.

Since the TS1 barrel experienced a nasty co-mingling with the Asso piston, I've either got to buy another ts1 kit, or down size.

I'm really inclined to buy one of the MBD SIL factory200 kits http://www.lambrettaspares.com/sparepar ... 0044K.html

My plan is to mate this kit with a new 58 MEC crank, new 24 mil mikuni and the taffy pipe. The header was the missing component to my plan.

Again, thanks sooo much for pointing me in the right direction.

Chris