recently rebuilt engine, it ran fine for 30 miles then died, ran briefly, then died again. I stripped the carb and it ran ok for a couple of miles then died again. Another (serious!) carb strip, this time it will only tick over, now it fires when kicked over but will not run.
Today i changed the coil, ht lead, cap and plug, no change, I turned the engine over with a drill, only very slight arcing around the points, no sign of leaking oilseals, comression fine, spark seems fine. Timing is a worry as i set it at 19btdc but to get it the stator is fully rotated anti-clockwise, apart from that im at a loss as to what to try next
Any ideas????
ps its a sr175 barrel, 18mm ma18bs5 carb and standard series 2 exhaust
Baffled!
-
- registered user
- Posts: 214
- Joined: Fri Feb 19, 2010 5:33 pm
- Contact:
- sean brady scooters
- Dealer
- Posts: 2040
- Joined: Mon Jan 05, 2009 12:09 pm
- Location: Ripon, North Yorkshire
- Contact:
POINTS...omg...lol
try a new condensor then....better still ,chuck it in the bin and treat yourself to electronic.
try a new condensor then....better still ,chuck it in the bin and treat yourself to electronic.

Sean Brady Scooters - 01765 690 698
-
- registered user
- Posts: 214
- Joined: Fri Feb 19, 2010 5:33 pm
- Contact:
would that be the same electronics that are sold with razor sharp wire holes that short out wrecking the cdi???? 
