Scooterotica

Anybody used them? From what I see they're available from Pm and Fatts......is there much difference and are they ready to fit or need paint/laquer etc??

They come all set to go.

I know two people that have had the PM ones and those were far from fit first time.
One was built at Interscooters in Coventry by Steve Connelly and there was lots of hours getting a full set to fit.

i got a set from pm, one panel was ok but the other side nowhere near a proper fit had to send it back and get a replacement . ive got carbon parts from both pm and fatty and the quality is the same its just fatty has more avalible items that are carbon , they both come ready to clip on .

I've always been a little disappointed at seeing larger carbon panels close up. They look good from a distance but in truth they look like a poor fit and see through legshileds but worse is the finish, as it doesn't stay shiney for long and can soon look a bit dull. Having said that, I love it for under panels and smaller items,

my ones are cheaper too have a look on the website mate all on ther now
http://fatt-speed.co.uk/default.aspx

fattspeed wrote:my ones are cheaper too have a look on the website mate all on ther now
http://fatt-speed.co.uk/default.aspx

IMO Seans Carbo are good ,also his fibreglass are the biz

Ive just bought a full set of Fibre off him, and well inpressed with the quality, lightness, fit and with strength
I initially was going Carbon, but we discussed and since I was going for a sprayjob decided fibre best route & value for money.

Contact Kenny at KB Paintshop 01482 225999- Hes painted a few of these panels up (Think he did the full Carbon one in Scootering mag a few years back -7H?)

Thanks for the info chaps, I'll be giving Shaun a ring soon.

If anybody has any pics of scoots with said carbon bits that'd be great....



Cheers again

Adam

here are some pics of our stuff see more at www.lambrettainnovation.co.uk