Page 1 of 2

Cracking Stainless Rims !!!

Posted: Fri May 14, 2010 9:41 pm
by Toddy
Had a mates Scooter round last week to fit some new rims as one of the Studs was turning , we changed it from Stainless wide rims to Steel Chrome wide rims under closer inspection we found the following faults where i have marked :shock: :shock:
on one rim (sorry for the quality of the pictures) there were cracks in nearly every area of the rims and the other side was half as bad, one crack as marked has nearly joined from one side to the next could have been very nasty , he also has stainless on the Front (not Wide) and after checking these they seem fine but he is going to change them now .

I just posted thios as a word of warning to people with Stainless split rims (Not Tubeless) the lad canyt remember where he got them from but i think that stud going has saved him from a very nasty accident !!!!

Image

Image

Image

Image

Re: Cracking Stainless Rims !!!

Posted: Fri May 14, 2010 9:44 pm
by RICSPEED
most dealers wont stock stainless rims for this reason

Re: Cracking Stainless Rims !!!

Posted: Fri May 14, 2010 9:59 pm
by bazman
What make are they?
Been running a set front and back for four years now no problems.

Re: Cracking Stainless Rims !!!

Posted: Fri May 14, 2010 10:01 pm
by oldbiker
Scarry stuff :o

Re: Cracking Stainless Rims !!!

Posted: Fri May 14, 2010 10:20 pm
by soulsurfer
bazman wrote:What make are they?
Been running a set front and back for four years now no problems.
Maybe not today, maybe not tomorrow but keep your fingers crossed and maybe, just maybe never, BUT, personally I'd change them as a matter of safety for you and others.

Re: Cracking Stainless Rims !!!

Posted: Fri May 14, 2010 11:41 pm
by Speed Demon

Re: Cracking Stainless Rims !!!

Posted: Sat May 15, 2010 8:43 am
by bazman
soulsurfer wrote:
bazman wrote:What make are they?
Been running a set front and back for four years now no problems.
Maybe not today, maybe not tomorrow but keep your fingers crossed and maybe, just maybe never, BUT, personally I'd change them as a matter of safety for you and others.
:lol: You an evangelical preacher on the religion of lammy rims Mike....(only joking fella ;) )
Looking at the photo's they do seem a tad thinner than my ones , i did hear that they changed the thickness that's when they started having problems, like i say been on for nigh on 4 years AND regularly checked over ( as i seem to do a rear tyre quite often :oops: )
Food for thought though cheers :)

Re: Cracking Stainless Rims !!!

Posted: Sat May 15, 2010 9:52 am
by soulsurfer
bazman wrote:You an evangelical preacher on the religion of lammy rims Mike....(only joking fella ;) )
Lambretta Safety And Quality Products Association (LSQPA, Nice ring to it eh?) :lol: ) ;) On a mission to stop us being fobbed off with shite :D

Re: Cracking Stainless Rims !!!

Posted: Sat May 15, 2010 11:12 am
by Bilko
Horrific!

I know someone personally & was witness to an accident due to stainless rims splitting

Re: Cracking Stainless Rims !!!

Posted: Sat May 15, 2010 11:30 am
by RICSPEED
there was one featured in scootering where about a quarter of the rim edge had come away whilst been ridden