Scooterotica

just glad you are ok

here are some alternative levers for those that want to upgrade

cnc machine nice ones with reach adjustment.

http://tyga-performance.com/site/index. ... =72_78_104

Ooh! They're a bit nice.....................

yes and not ott priced either, the reach adjustment is well worth it

cezeta wrote:here are some alternative levers for those that want to upgrade

cnc machine nice ones with reach adjustment.

http://tyga-performance.com/site/index. ... =72_78_104

How do you know what lever will fit? Are they universel? I have a master cylinder bought from CAM LAM for a Series 2.

cezeta wrote:here are some alternative levers for those that want to upgrade

cnc machine nice ones with reach adjustment.

http://tyga-performance.com/site/index. ... =72_78_104

Hmm, like everyone else I've just been out and checked mine. 21D, like Sef's........... But no signs of the cracks, in fact it looks quite good quality (and I know what good quality looks like having worked in precision engineering all my life ).

Anyway, I'm tempted by one of the levers Cezeta mentioned.

Does anyone know which one would fit

I think i should reply to Randalls last post. Randall says that he has not recieved the emails that i sent and that may be true, even though they were all sent multiple times from diffrent accounts. I contaced him via the forum as i couldnt get any joy any other way and he pm,d me back simply saying i will not talk on here contact me via the shop. This i tried again and still no joy i also pmd him again but he chose to ignore this as well. The mail he has pasted in was about the 10th id sent by this time and i will admit i was pretty pissed off by then. strange that he can find this email but none of the others i have sent. apart from that he has now seen the pics like everyone else and still he hasnt contacted me.

To be fair hes probably right when he says there are thousands of these out there without any problems, but thats not the point is it. People have asked sensible questions on here , what batch where they from where were they sourced from, and so on. He has refused to answer these questions, I will leave you to wonder why that might be?

It aint hard, if you sell somthing for a profit to a consumer then you are responsible for said item. If the item you have sourced has failed then you will or should chase the manufacturer a) to find out why this happenend b) to ensure they take steps to make sure it doesnt happen again. C) to claim monies back mif you had had to make a payment to the customer.

Trading standards would rip him apart, end of!

4 weeks still no reply

sef

The UK distributors for those levers are in Manchester. I'll try and see if they're open to the public (they might be internet only) and take a master cylinder down to see if they fit. I'm over there fairly regularly, unless there's anyone on here Manchester based?

nice one corrado. they look the same but i know that some differ where the bolt goes through in thickness.

cezeta wrote:nice one corrado...

yeah, I'd be interested in that too, not because the supplied lever is concerning me [due to this thread, I have checked it and it's fine], but these do look a bit trick.
slightly OT, but do you [corrado] supply replacement pads ? I'll pm you.

I will be fitting a recently purchased ScootRS disc on a mate's bike soon, it will be interesting to see how it compares with syd's