Scooterotica

Getting there mate ..cant wait to see it done

http://m.facebook.com/?_rdr#!/groups/13 ... 0506934173


link to cutdown group

ssteam177 wrote:Mick, that looks like a western Australian plate??? Now I see why it wont be @LoW:)

Your not wrong Shane!

Mick that looks s**t hot!!!! Are you going to be taking this to the gold coast???

Fenian Mick wrote:

ssteam177 wrote:Mick, that looks like a western Australian plate??? Now I see why it wont be @LoW:)

Your not wrong Shane!

Fantastic, when I said I couldn't wait to see the finished article I thought it would be pics! Now maybe I'll get a chance to see it in the flesh so to speak

ssteam177 wrote:Mick that looks s**t hot!!!! Are you going to be taking this to the gold coast???

Fe#k I think it's nearer to IOW than Gold Coast from here!

Minority you'll defo get to see it soon it's been too long in the building so dead keen to be out n about on it

Mick ,Daz here mate, that thing is begging for a better motor, send me the cylinder and case and i will get to work on it, fantastic job , cant wait to see it.

Very,very nice Mick.When are you coming over to SA again ?

Cheers Nick.

RAP 200 wrote:Mick ,Daz here mate, that thing is begging for a better motor, send me the cylinder and case and i will get to work on it, fantastic job , cant wait to see it.

Daz thanks for the offer mate but engine should be good enough, it's a Broady ported cylinder and case , self built and for one up riding. Still want you to do the TS 240 though.

Nick , thanks for the comments. Won't be over to SA this year but next autumn I was hoping to be over when you LCSA lads were on a long weekend away.

I was lucky enough to see this in the flesh today. It is truly stunning and will raise the bar when it's on the road. You do great work Mick.

Not had time to do much lately... but got most of the wiring, hoses and cables done



front mudguard fitted and twin brake hoses secured, digital speedo prox switch and magnet










The headset is wired and hosed in... had to work it all in very neat and tidy as there is two hoses and extra wires and joiners for the digital speedo,rev counter and engine temperature







Seat now fitted after all wiring for reg, CDI and M tech ignition box were wired under the arch
















Waiting on a pressure switch for the rear brake so i can set up the rear brake without the wheel on then fit the rear guard, tank and ready for blast off