Re: MZ cylinder head for Lambretta 200cc
Posted: Tue Aug 16, 2011 11:10 pm
sydduckett wrote: .....no rush like....
Scooterotica
The UK's No1 Lambretta & Vespa Scooter Forum.
https://www.scooterotica.org/forum/
MZ cylinder head for Lambretta 200cc
Page 6 of 8
Re: MZ cylinder head for Lambretta 200cc
Posted: Tue Aug 16, 2011 11:17 pm
RICSPEED wrote:sydduckett wrote: .....no rush like....
Re: MZ cylinder head for Lambretta 200cc
Posted: Wed Aug 17, 2011 12:28 pm
Seek and ye shall find, ask and ye shall receive.....pay and MB will send it!! ;o))
Low comp, centre squish, large fin, air-cooled cylinder head, profiled to 70mm TS1 race-tour piston.
Low comp, centre squish, large fin, air-cooled cylinder head, profiled to 70mm TS1 race-tour piston.
Re: MZ cylinder head for Lambretta 200cc
Posted: Wed Aug 17, 2011 1:48 pm
Perhaps mr. Green can tell also something about the head on his racer.
fishi[/quote]
Yes,... I could do I suppose.......[/quote]
OK, then please let us know what head you use. Is it an MB one, too ?
Started off as an MB Blank. then machined by Chalkies to suit.
Yes I have a picture of it.. No it won't be on here
fishi[/quote]
fishi[/quote]
Yes,... I could do I suppose.......[/quote]
OK, then please let us know what head you use. Is it an MB one, too ?
Started off as an MB Blank. then machined by Chalkies to suit.
Yes I have a picture of it.. No it won't be on here
fishi[/quote]
Re: MZ cylinder head for Lambretta 200cc
Posted: Wed Aug 17, 2011 4:12 pm
jb do a fibre glass scoop im told if you need onedrunkmunkey6969 wrote:Seek and ye shall find, ask and ye shall receive.....pay and MB will send it!! ;o))
Re: MZ cylinder head for Lambretta 200cc
Posted: Wed Aug 17, 2011 4:26 pm
lovely job.....any ideas on prices?RICSPEED wrote:jb do a fibre glass scoop im told if you need one
i'll email him tomorrow....
Re: MZ cylinder head for Lambretta 200cc
Posted: Wed Aug 17, 2011 4:27 pm
i would not think they will be much dan ..i will pmdrunkmunkey6969 wrote:lovely job.....any ideas on prices?RICSPEED wrote:jb do a fibre glass scoop im told if you need one
i'll email him tomorrow....
Re: MZ cylinder head for Lambretta 200cc
Posted: Wed Aug 17, 2011 10:07 pm
The fibreglass scoops are a lot of money for what they are ! £40. + I think...."
I made one from a sheet of aluminium... Got some pics somewhere will look them out!
I made one from a sheet of aluminium... Got some pics somewhere will look them out!
Re: MZ cylinder head for Lambretta 200cc
Posted: Wed Aug 17, 2011 11:06 pm
I'm considering a better air intake device.
Just thought I'd share.
Just thought I'd share.
Re: MZ cylinder head for Lambretta 200cc
Posted: Wed Aug 17, 2011 11:32 pm
i would too personallypaulmgreen wrote:The fibreglass scoops are a lot of money for what they are ! £40. + I think...."
I made one from a sheet of aluminium... Got some pics somewhere will look them out!