Scooterotica

that triumphs one for the bobber thread on sbw eh joe

RICSPEED wrote:that triumphs one for the bobber thread on sbw eh joe

yeah id say so mate its a belter
dave hope yer dont mind but ive posted it on to the sbw thread mate

No mate no problem. well the PRISM TANK it is then thanks...

Now in this months may edition of B.S.H.

cool ...bsh is worth picking up if only to read ogri

so,what happend to that then,madness?
have you ever tried a hardtail on a lammy?
is that safe,or do you think the mounts of the engine will crack?

schniedel wrote:so,what happend to that then,madness?
have you ever tried a hardtail on a lammy?
is that safe,or do you think the mounts of the engine will crack?

Iv just had loads of engine tuning this month and for the next 4 months so iv had no time mate and yes iv done about 7 hard tail choppers and cutdowns in the past just never took any photo's i'll have to do some more on the old chop when i get chance. iv been doing a very nice series 1 for my self should look ok when i get the time to finish it

I am building a hard tail lammy, big rubber mounts in between the replacemement bar for shock. I have done this mainly because lambretta choppers in my humble opinion look rubbish at the back, with the shock sitting high at the back. I am also not exactly a fan of choppers being tall at the front, i like a longer lower look if you are going to chop it.

smiffy1968 wrote:I am building a hard tail lammy, big rubber mounts in between the replacemement bar for shock. I have done this mainly because lambretta choppers in my humble opinion look rubbish at the back, with the shock sitting high at the back. I am also not exactly a fan of choppers being tall at the front, i like a longer lower look if you are going to chop it.

Each to there own. Sounds good you goa any photo's ???

i'll try and stick some on.