Page 5 of 5
Re: Reedvalve - any suggestions for a smallblock?
Posted: Fri Feb 27, 2015 1:55 pm
by Andy W
Well I have borrowed a Fran Road pipe and a TSR Evo to try this weekend, plan to try the raod pipe tonight and then the Evo over the weekend. will let you know what I think once done.
Which other end cans will fits these as I note they are quite large in diameter and sits close to the panel?
Mine is a Gp so may not become an issue but will let you know.
Re: Reedvalve - any suggestions for a smallblock?
Posted: Fri Feb 27, 2015 3:58 pm
by Minority
Andy W wrote:Well I have borrowed a Fran Road pipe and a TSR Evo to try this weekend, plan to try the raod pipe tonight and then the Evo over the weekend. will let you know what I think once done.
Which other end cans will fits these as I note they are quite large in diameter and sits close to the panel?
Mine is a Gp so may not become an issue but will let you know.
Darrel Taylor of Taylor Tuning does a nice carbon end can for the EVO I believe.
Re: Reedvalve - any suggestions for a smallblock?
Posted: Sat Feb 28, 2015 11:17 am
by alanscottj
Can't believe the difference the reed valve has made. Just been for a spin and it's like a different scoot. Acceleration is amazing, sounds great. Not sure if I need to rejet as my scoot was set up very rich before so I think it might be ok. EGT is in a good range but haven't had it on the dual carriageway yet to see what the temp goes to at full throttle.