Page 4 of 12

Re: Aprillia RS125 smallie engine

Posted: Sun Apr 25, 2010 7:42 pm
by twin
they have done 2 lots for me both on twin engined scoots,

Re: Aprillia RS125 smallie engine

Posted: Wed Apr 28, 2010 3:51 pm
by Wayne Miller
Cheers lads Ive just spoken to the guys today, Im taking the scooter in to them in about three weeks (Need some build time for the engine) They can build me a pipe to work with the tune and powervalve and route it where I like all for £295!!!!! a fookin bargain in my book.

Thanks again I owe you both a pint or two . . . . . . . You'll just have to catch me and prise my wallet open first :frog: :frog: :frog:

Re: Aprillia RS125 smallie engine

Posted: Wed Apr 28, 2010 9:37 pm
by Wayne Miller
I also found a link to there site http://www.tdrscooters.com/index.php

Re: Aprillia RS125 smallie engine

Posted: Thu Apr 29, 2010 8:15 pm
by twin
what did i say,

Re: Aprillia RS125 smallie engine

Posted: Fri Apr 30, 2010 5:00 pm
by Wayne Miller
A couple of pics of the porting work on the packer and casings :frog:


Image

I just need to fill in the hole on the right and fill around the casing bolt at the bottom, polish up the transfers and bobs yer uncle I can put it together :D :D :D :D :D :D

Image

Re: Aprillia RS125 smallie engine

Posted: Fri Apr 30, 2010 5:01 pm
by sean brady scooters
that looks great Wayne :D

Re: Aprillia RS125 smallie engine

Posted: Sat May 01, 2010 11:52 am
by Wayne Miller
sean brady scooters wrote:that looks great Wayne :D
Yup, the little beasties gonna have a great pair of lungs :baddevil:

Re: Aprillia RS125 smallie engine

Posted: Sat May 01, 2010 7:29 pm
by J1MS
Looking very good. 8-)

Re: Aprillia RS125 smallie engine

Posted: Sat May 01, 2010 8:27 pm
by oldbiker
Looks like all the work and parts are coming together, Looks very nice

Re: Aprillia RS125 smallie engine

Posted: Mon May 24, 2010 2:52 pm
by Wayne Miller
Nearly there now :twisted: The engine has been built minus clutch but Ive had to sling it in as its due to go into TDR tomorrow to have an exhaust made. Ive also had to skim 1mm off the bottom of the barrel to give me a negative deck height of -1mm. This has given me Ex 194 Trans 125.5

Image

Image

Image

Image