Scooterotica

scootRS.com wrote:

gaz_powell wrote:get the scootrs kit from just lambretta

They don't carry our carb kits. Yet...

I've got the 24 mm kits for both size cylinders.

I was thinking of the 30mm, and saw no photo up of the 24mm, sorry. Shows what little I know

Why did I used to read that the 24 Mikuni is a nightmare to get the jetting set well on? Or was that the 28TM? The 35tmx is certainly nice on an RB.

the 28 needs a little more attention, the 24 is as easy as pie, would be good to see them on site

All the reports I've read about the TM24 have been glowing to the extreme. Trouble is what ever I go for will be an expensive lesson if I don't get the desired result i.e. smother more responsive and dare I say it more reliable engine

once setup, the mikuni won't let you down.

you can add whatever manifold you want right on the page. or make a note at checkout that you want a complete setup for a whatever CC running through the stock airbox. i'm a pretty reasonable man to deal with

no point in having a kit for every configuration possible. you get a load of jets to suit most any setup. if you run open you're good. if you want to run a remote filter we've got you covered. stock airbox? you bet. 150, 200? got it all.

the 28 that is the difficult one - the black sheep of the TM lineup

Buy a Mikuni, you know you want to...

Gone for 28mm dellorto + small block inlet manifold......has come off a 175 so will need to check jetting/buy choke cable kit/rubbers + clamps...got long throttle cable. perhaps SH2/22 choke assembly will fit.

used both the 30mil delly and the mikuni 24 from jet 200 this week......mikuni all the way for me!

mickeyb wrote:used both the 30mil delly and the mikuni 24 from jet 200 this week......mikuni all the way for me!

You pay your money and take your chances................