Page 3 of 3
Re: TSR Exhaust Vs ADS3 and the missing tailcan bracket deba
Posted: Mon Dec 01, 2014 3:15 am
by DMC
Does the 'short' bracket need to be bent at 90 degrees? with the round hole fitting to the lower rear damper mount? Only way I can see it fitting.
Re: TSR Exhaust Vs ADS3 and the missing tailcan bracket deba
Posted: Mon Dec 01, 2014 10:07 am
by MAB
Regarding the mounting bracket they are the same that come with the Bullet and Hornet ect ,I have had 3 in totally some pre/bent from maker and one I had bent myself and all fairly useless to be honest .
Re: TSR Exhaust Vs ADS3 and the missing tailcan bracket deba
Posted: Mon Dec 01, 2014 12:34 pm
by slangen
Re: TSR Exhaust Vs ADS3 and the missing tailcan bracket deba
Posted: Mon Dec 01, 2014 6:28 pm
by Donnie
Hmmm that does seem to me like an afterthought :-/
Re: TSR Exhaust Vs ADS3 and the missing tailcan bracket deba
Posted: Mon Dec 01, 2014 8:23 pm
by shocky
You could easily make a 3 point side case bracket
Re: TSR Exhaust Vs ADS3 and the missing tailcan bracket deba
Posted: Mon Dec 01, 2014 8:42 pm
by slangen
It's not my side case, this is a Bullet or Voyager from Pipe Design. I posted the pictures long ago when someone asked how to use the bracket.
Re: TSR Exhaust Vs ADS3 and the missing tailcan bracket deba
Posted: Fri Dec 12, 2014 11:57 pm
by gaz_powell
