Page 3 of 3
Re: Advice on measuring squish
Posted: Sun Mar 25, 2012 6:17 pm
by djh66
If I had a brain I'd be dangerous
After reassembling and measuring again, I'm now getting 1.47mm, Without a base gasket.
I think I wasn't getting my twist of solder in the right place!
Thanks to all for help and for RichT for advice.
Re: Re: Advice on measuring squish
Posted: Sun Mar 25, 2012 7:27 pm
by drunkmunkey6969
Darrell Taylor wrote:thats about correct Dan , wow 4.46 am sounds like u had a good night out
My daughter was up from 3.30am with an ear infection, so that was my kip finished whilst I waited for calpol to kick in (for her, not me
) Still.....always got time for an interesting question on the forum no matter what the time of day/night! LOL ;o)
Sent from my HTC Sensation using Tapatalk
Re: Advice on measuring squish
Posted: Sun Mar 25, 2012 7:43 pm
by cezeta
djh66 wrote:If I had a brain I'd be dangerous
After reassembling and measuring again, I'm now getting 1.47mm, Without a base gasket.
I think I wasn't getting my twist of solder in the right place!
Thanks to all for help and for RichT for advice.
well done, you got there in the end. 1st time i did it i dropped the solder into the barrel like a knob then i had it poked it the exhaust and cut the end off.....takes a while to get the knack of some things.