After reassembling and measuring again, I'm now getting 1.47mm, Without a base gasket.
I think I wasn't getting my twist of solder in the right place!
Thanks to all for help and for RichT for advice.
Advice on measuring squish
-
djh66
- registered user
- Posts: 369
- Joined: Sun Jan 31, 2010 12:19 pm
- Main scooter: 150 special
- Location: Bedford UK
- Contact:
If I had a brain I'd be dangerous
After reassembling and measuring again, I'm now getting 1.47mm, Without a base gasket.
I think I wasn't getting my twist of solder in the right place!
Thanks to all for help and for RichT for advice.
After reassembling and measuring again, I'm now getting 1.47mm, Without a base gasket.
I think I wasn't getting my twist of solder in the right place!
Thanks to all for help and for RichT for advice.
Bring Me Sunshine COYH
-
drunkmunkey6969
- Moderator
- Posts: 2838
- Joined: Sun Jan 04, 2009 1:42 pm
- Main scooter: '69 Lambretta GP
- Location: North Yorkshire
- Contact:
My daughter was up from 3.30am with an ear infection, so that was my kip finished whilst I waited for calpol to kick in (for her, not meDarrell Taylor wrote:thats about correct Dan , wow 4.46 am sounds like u had a good night out
) Still.....always got time for an interesting question on the forum no matter what the time of day/night! LOL ;o)Sent from my HTC Sensation using Tapatalk
See our YouTube scooter channel for Tech-help: https://www.youtube.com/c/TheScooterFactory/videos
djh66 wrote:If I had a brain I'd be dangerous
After reassembling and measuring again, I'm now getting 1.47mm, Without a base gasket.
I think I wasn't getting my twist of solder in the right place!
Thanks to all for help and for RichT for advice.
well done, you got there in the end. 1st time i did it i dropped the solder into the barrel like a knob then i had it poked it the exhaust and cut the end off.....takes a while to get the knack of some things.