Scooterotica

I was wondering if anyone had successfully modified or cut down the foam, on a filter like this to fit under the side panel? Or found a filter that will fit a 30mm VHSA?
Thanks.

Thanks for the reply on the bracket. It looks like I can figure it out from there. So simple, I love it when its basic and functional.

Have you considered a marchald filter?
http://jet200.com/catalog/product_info. ... cts_id=748

I would also consider attaching a rubber hose to the carb mouth and angling it rearwards so its nearly horizontal, then put the filter on the end of that. I used a thin walled aluminum tube to keep it rigid. The tip would have to end near the strut. Not alot of room you have to work with that huge tank.

exellent bike....the seat is killing it though.....

camel wrote:exellent bike....the seat is killing it though.....

I have to agree. The whole Lambretta is superb, I love it, except for the seat. A wee Ancilotti and it would be perfect

The marchald filters I've seen on the dyno have been quite restrictive especially with the panel on as I think the front will still touch. The camlam breath sweet fit series 3s with MB manifolds but I'm not sure about on Rons kits.

Added a motorbike GPS to Gorrilaz's, it goes great.
It can be operated wearing gloves, Bluetooth etc.
Cheap as well

where was that GPS from may i ask and how much?

CANbus wrote:Added a motorbike GPS to Gorrilaz's, it goes great.
It can be operated wearing gloves, Bluetooth etc.
Cheap as well

Very nice

I bought my GPS with maps included from a reseller. However it looks like you can them from the link pretty cheap but without the software.
The operating system is widows CE, the software required would be something like primo 2 iGO8, which is readily available off the internet.

I may get a HD camera from them next?


http://www.chinavasion.com/china/wholes ... _Navigator

looks great.........well done pal.