Scooterotica

cable routing or not using a nylon lined cable or uneven height springs

joeythescooterboy wrote:

celt wrote: any ideas

Yes Richie lad, get yourself a Vespa!!

Over my dead body Joey

mark wrote:cable routing or not using a nylon lined cable or uneven height springs

Cable is routed correctly and using a nylon line cable. As I said before springs are the same hight and ground on either end. Thanks for the input though

Diablo wrote:A set up that I've used with success is to use uprated springs with std Vespa springs over the top. This gives extra spring pressure but with a useable lever.

This is probably your best option without looking at 5/6 plate options. Are the steels still flat if laid on a piece of glass?

[/quote]
This is probably your best option without looking at 5/6 plate options. Are the steels still flat if laid on a piece of glass?[/quote]

Good question, I didn't think of that If I have to take apart again I will try that