Page 2 of 2
Re: KEGRA 38mm manifold for Iron barrels
Posted: Wed Jan 06, 2010 6:16 pm
by Adspeed
Was in Chiselspeed today Martin said he can do you one of these at any length for ya 38mm Dellorto.
Just give him an email if any good to ya -
[email protected]
Re: KEGRA 38mm manifold for Iron barrels
Posted: Wed Jan 06, 2010 6:47 pm
by Ian Hepworth
It won't have kegra on it though so no good for this chap.
Re: KEGRA 38mm manifold for Iron barrels
Posted: Thu Jan 07, 2010 10:07 am
by fishi
Adspeed wrote:Was in Chiselspeed today Martin said he can do you one of these at any length for ya 38mm Dellorto.
Just give him an email if any good to ya -
[email protected]
Hi ADSPEED !
is this a standard CDC manifold opend to 38mm ??
or a special cast item like the KEGRA ??
I can not imagine that a CDC can be opened to 38mm-40mm !!!
fishi
Re: KEGRA 38mm manifold for Iron barrels
Posted: Thu Jan 07, 2010 8:21 pm
by Adspeed
fishi wrote:Adspeed wrote:Was in Chiselspeed today Martin said he can do you one of these at any length for ya 38mm Dellorto.
Just give him an email if any good to ya -
[email protected]
Hi ADSPEED !
is this a standard CDC manifold opend to 38mm ??
or a special cast item like the KEGRA ??
I can not imagine that a CDC can be opened to 38mm-40mm !!!
fishi
He can MOD a CDC for ya thats all.....the one above is not modded its for a Mikuni but was meant as illustration.
OK unless you find a KEGRA one from a somebodys garage you ain't getting one as KEGRA have none, aren't ordering anymore and only stock the MB one.
I can do no more..........
Re: KEGRA 38mm manifold for Iron barrels
Posted: Thu Jan 07, 2010 8:27 pm
by Adspeed
Ian Hepworth wrote:It won't have kegra on it though so no good for this chap.
Re: KEGRA 38mm manifold for Iron barrels
Posted: Thu Jan 07, 2010 8:35 pm
by Andy Pickering
Guess it is MB then...whats wrong with MBs CDC Ive had loads over the years..
Re: KEGRA 38mm manifold for Iron barrels
Posted: Fri Jan 15, 2010 10:13 pm
by Adspeed
I'm reliably informed that Kegra have found two of these manifolds.
Their email is down so give them a ring.
Re: KEGRA 38mm manifold for Iron barrels
Posted: Tue Jan 19, 2010 9:15 am
by fishi
Hi Adspeed !!
can not phone KEGRA !!!
I am worry about them, do not understand why they do not respond to my mails !!!
I can not imagine that their e-mail do not work !!!
fishi
Re: KEGRA 38mm manifold for Iron barrels
Posted: Tue Jan 19, 2010 11:14 am
by drunkmunkey6969
fishi wrote:Hi Adspeed !!
can not phone KEGRA !!!
I am worry about them, do not understand why they do not respond to my mails !!!
I can not imagine that their e-mail do not work !!!
fishi
So you have lost the ability to use a telephone, and they are lying about thier email being down as a crafty rouse.....hmmm interesting. :ninja:
