Page 2 of 2
Re: any demand for these in brass
Posted: Sun Dec 20, 2009 12:46 am
by boonyed
I'll have a set please!!
Re: any demand for these in brass
Posted: Wed Dec 23, 2009 2:03 pm
by davidblythe
1st small length of brass arrived today
3 more small lengths ordered, hopefully come tomorrow
found a supplier sells by the bar
One bar length ie 3 metres is £38 plus Vat plus £25 delivery irrespective of no of bars delivered
in steel can get 5 bar for £35 delivered
make first set tonight
Re: any demand for these in brass
Posted: Wed Dec 23, 2009 7:39 pm
by davidblythe
Re: any demand for these in brass
Posted: Tue Dec 29, 2009 1:04 pm
by markdicko
could i purchase a set please!
Re: any demand for these in brass
Posted: Tue Dec 29, 2009 3:05 pm
by davidblythe
markdicko wrote:could i purchase a set please!
in the post tomorrow Mark
Re: any demand for these in brass
Posted: Tue Dec 29, 2009 4:34 pm
by dirtyhandslopez
davidblythe wrote:markdicko wrote:could i purchase a set please!
in the post tomorrow Mark
They are done then? Who is on the list to get a set? I have a Mikek here that would love to meet them
Sorry 'bout that, just saw the add in the market place
Re: any demand for these in brass
Posted: Tue Dec 29, 2009 6:25 pm
by davidblythe
dirtyhandslopez wrote:davidblythe wrote:markdicko wrote:could i purchase a set please!
in the post tomorrow Mark
They are done then? Who is on the list to get a set? I have a Mikek here that would love to meet them
Sorry 'bout that, just saw the add in the market place
No worries on getting the brass now
did one set for a Mickeck, tightest curve on the U bend I have seen, it worked in the end but not an easy of the shelf if that makes sense, is the distance between flange and hitting the U Bend in a straight line 20mm if so can be done buy may need you to drill the holes in the correct place
