I'm sure someone was selling stainless nyloc 'half-nuts' to stop tightening the shock up too much. Anyone know who it is? I had stainless dome nuts on which were loctited , but backed off a touch.Great idea that was,both gone by time I got back from Rhyll testerday :biggrin:
Thanks.
R1 shock.What's yous set up?
-
Ihateyoubutler
- registered user
- Posts: 244
- Joined: Thu Jan 08, 2009 4:13 pm
- Location: North west
- Contact:
mb do them for the bgm shock and keith at redoglambrettas i just bought full nuts and hack sawed them down then rubbed the cut on some course emery to flat them down
We sleep soundly in our beds because rough men stand ready in the night to visit violence on those who would do us harm
-
Ihateyoubutler
- registered user
- Posts: 244
- Joined: Thu Jan 08, 2009 4:13 pm
- Location: North west
- Contact:
Thanks Shocky.
Unfortunately, if I try to cut anything with a hacksaw,it starts off square, then ends up anything but :biggrin: . If I need a 30cm length of pipe, I have to start at 50 and by the time the saw has come out the other side, it may just be what I need. It would take months of work to get eventually anywhere near a 90 degree end product!
Thanks again.
Unfortunately, if I try to cut anything with a hacksaw,it starts off square, then ends up anything but :biggrin: . If I need a 30cm length of pipe, I have to start at 50 and by the time the saw has come out the other side, it may just be what I need. It would take months of work to get eventually anywhere near a 90 degree end product!
Thanks again.