Page 2 of 2

Re: Poorly Lammy

Posted: Mon Feb 18, 2019 11:28 pm
by MightyGem
OK. Thanks. Seems like some work needs doing.

Re: Poorly Lammy

Posted: Wed Apr 03, 2019 10:08 pm
by MightyGem
It would appear that the last time I stripped the carb down, when I put it back together I didn't put the needle valve in it's little slot on the float, but just put it on top of the float, because that's where it was found. Ho hum. :oops: :oops: :oops:

No other fault found.