Re: Flywheel fitting - too tight
Posted: Mon Mar 19, 2018 12:33 am
Li taper
Scooterotica
The UK's No1 Lambretta & Vespa Scooter Forum.
https://www.scooterotica.org/forum/
Flywheel fitting - too tight
Page 2 of 2
Re: Flywheel fitting - too tight
Posted: Mon Mar 19, 2018 12:36 am
For some reason pics not working very well
Re: Flywheel fitting - too tight
Posted: Mon Mar 19, 2018 12:50 am
Re: Flywheel fitting - too tight
Posted: Mon Mar 19, 2018 12:54 am
Re: Flywheel fitting - too tight
Posted: Mon Mar 19, 2018 10:29 am
Hi there, Thanks again for the pics and I will have a look this week when I can get some time and hopefully get to the bottom of this problem. Will post an update once I get the chance to look.
Cheers!!!!
Cheers!!!!
Re: Flywheel fitting - too tight
Posted: Wed Mar 21, 2018 2:25 pm
OK, got round to revisiting the scoot last night and found one of the nuts on the stator plate not fully tightened!!!!! so with that secure flywheel back on and all good. Reconnected the carb, a few stabs on the kickstart and away we go!
Big thanks to everyone on the help and suggestions. Saved a lot of time and effort!
Big thanks to everyone on the help and suggestions. Saved a lot of time and effort!
Re: Flywheel fitting - too tight
Posted: Wed Mar 21, 2018 9:31 pm
I’ve just had the same problem, first time ever. Did it have s**t colored brown paint on the inside on the flwheel?
Re: Flywheel fitting - too tight
Posted: Thu Mar 22, 2018 3:51 pm
Some flywheels have a kind of brown coating inside. I assume its to stop the magnets rusting etc. Wont stop it working though in my experience.
Re: Flywheel fitting - too tight
Posted: Thu Mar 22, 2018 9:31 pm
No brown mess on this one. 