Scooterotica

ive got a picture of a challenger, if its the one your talking about, its not the same as mine, mine has all 4 studs in a non standard position, looks like the challenger uses std stud position, my transfers are much bigger too, any other ideas ?

ive found some pictures on this site of a kx250 it is similar to mine, but its got an 80mm spigot, mine is 75mm anyone know which cylinder i need?
[imghttp://i1168.photobucket.com/albums/r500/holty1966/25022007092_zpswx6tppey.jpg][/img]

lambretta based 200 alloy type barrel thts been heavily welded; me guesstimate ifin its a 75mm spigot; off set stud pattern similar to standard case; challenger mabee ts1; not offset so a bike barrel conversion i guess

Why not give Harry Barlow a ring ?
He's a really nice bloke, super helpful and loves this kinda stuff.
0116 287 1285

thanks for that stokie, i will ring him later on today.

AF Bultaco?

SF

Perhaps not....tud spacing look similar but not the transfers. 3rd pic up from bottom.

http://www.lambrettaspares.com/info/mb- ... 1-+91.html

I have challenger trying to get pictures on here

Sent from my HTC One_M8 using Tapatalk

Someone let me know if you can see them please


Sent from my HTC One_M8 using Tapatalk

can see it; looks very same as

is not same as yours