Page 2 of 2
Re: Pick up
Posted: Thu May 07, 2015 1:28 pm
by gaz_powell
dont forget to araldite the soldered joints
Re: Pick up
Posted: Thu May 07, 2015 9:07 pm
by Architecten
yup, all done...
Re: Pick up
Posted: Thu May 07, 2015 10:06 pm
by Yanker
Architecten wrote:I finished soldering up my stator last night after replacing the LT coil and pickup. It now reads 511 and 94 respectively. What happens when it goes back on the scooter is anyone's guess...!
94 is on the low side (out of tollerence) on the pick-up: should fire and run though!
Re: Pick up
Posted: Fri May 08, 2015 8:15 am
by Architecten
Yeh I know, but what's 1 ohm between friends! But it is higher than the one I took off, that was 82. The LT coil read 293. No wonder i couldn't ride it home from St Bees!!!
Re: Pick up
Posted: Fri May 08, 2015 2:49 pm
by coaster
I wouldn't worry about the pickup, it's on a par with most Indian coils I've tested, Italian ones read higher and the BGM ones are about 115 ohms