Scooterotica

Posted: **Wed Nov 12, 2014 4:58 pm**

It's gone into engineering company. £12 so probably than a DIY job

Posted: **Wed Nov 12, 2014 5:01 pm**

Posted: **Fri Nov 14, 2014 12:02 am**

All done and a good job but thanks for the advice.

Posted: **Fri Nov 14, 2014 6:11 pm**

Stokie wrote:how about one of these?

http://www.newmantools.com/flexhone/index.html

They get stuck in the ports and fly apart. I use these.

Posted: **Fri Nov 14, 2014 6:30 pm**

looks good where do you get them?
thanx

Posted: **Fri Nov 14, 2014 6:53 pm**

Sure it was MSC Industrial Supplies. Thats where I use to get most of me workshop sundries.
On their web site under bore polisher.

Glaze Busting