Re: lambretta frame jig work
Posted: Fri Nov 13, 2015 3:19 pm
that's a measure twice cut once if ever ive seen one
Hi.i have a series 1 frame so could measure this for you?Robi D wrote:Do you have any rough dimensions for series 1/2 frames? I have to replace the centre stand strut on my ser 2 and my legshields are a bit wavy yet to try and sort it that way. I'd rather some kind of dimensions. I'm a welder fitter by trade amd set in my ways!! Lots of info out there for ser 3 but not much for 1/2. I'm not sure of the placement of my rear hanger either. It looks good until the bottom where it's pressed together. I think it might be bent in towards the frame tube.
Thanks