Scooterotica

also, did you switch it out to a RD350lc trans or have you keep the stock Banshee?

Hi guys to answer the questions

I plan on using a center tank on the leg shields between where the radiators are mounted actually they are already finished just have not taken any more photos yet. I may also run a small tank directly above the engine as well with a balance tube between them. The gearbox is banshee to its all had allot of work done to it

Well here's the secret.... check out this link its the same as my engine but i am not running NOS yet!... take a deep breath before you watch it ha ha
http://www.wickedatv.com/movies/Wicked2Gainsville.MOV

Then think what it will be like in a LD will be a wild ride!!!

Hamish

Hi all been rather busy over here..... here is where we are up to at the moment.

Racked the front out more so sheee's nice and low... new seat base has also been fabricated.


Radiators are all fitted in ... lots of fabrication




Air cleaners are fitted us 2/12 inch stainless tube fabricated to fit




Hamish

she is really gorgeous..................
the scoots very nice too...............
its a really wonderfull project........looking forward to seeing some more pics.............

and the paint

With that back tyre, I want to see it tackle a roundabout

ArmandTanzarian wrote:With that back tyre, I want to see it tackle a roundabout

I was thinkin the same thing!!

possibly why he fitted the wide bars

Looking good ... Very good .... More pics please....

roundabouts may not be a prob.......................dont think they have them...............