Scooterotica

electrics going where frame starts ,blanking plate to make water tight, cdi + regulator, having retractable grab rail/rack built into seat

Hi
I see you have a twin engine auto in the lammy frame in the back ground of your pic,

not mine its rics his next project will be for sale

Just had a bit of fun with registering a scoot.....issues over the frame number which made me think, how will you go about the original frame number not being on the scoot in the correct place ?....might be issues at mot time....or with Plod

kept the old section hung up in shed cut original piece out and having it wlded onto down tube

just dry building at present

need to seal the tank any good sealants out there

Don't know about sealants but i prefer the look without the rear section fitted still each to their own eh

dont i have the same thought another bracket for plate and rear light small seat and its done mmmmmmmmmmmmmm

Is that a vortex carb or the new polini?