Scooterotica

jonny wadd wrote:Should of bought the lth disc brake

i am on a budget and a tight budget at that, its not a problem its just me, i like to see why it works or why it wont and in this case a spin inthe lathe will sort it . i just dont like the way it sits against the caliper bracket. oh and top avtar jonny :bigsm:

from this



to this



to this

simon ,i hope your new satellite (carlos fandago thingymebob)speed works ok cause you not get the speedo to work now!
i was going to sugguest to leave the speedo drive off and space it out with a machined washer but too late ethyl!

I would have taken it back to Blackpool

joespeed wrote:simon ,i hope your new satellite (carlos fandago thingymebob)speed works ok cause you not get the speedo to work now!
i was going to sugguest to leave the speedo drive off and space it out with a machined washer but too late ethyl!

it was doing me sweed in, every time i walked by it today in my workshop, tiredness and lack of patience was not helping ether. did not have any spare ally to turn down, so it had to have it, and i feel better now :bigsm:

Toddy wrote:I would have taken it back to Blackpool

ey up mate,

dont think there was owt wrong with it, as stated by scootrs the drum hub becomes universal when using the anti dive kit. its just me being picky :anbrgin;

tea5ive wrote:

Toddy wrote:I would have taken it back to Blackpool

ey up mate,

dont think there was owt wrong with it, as stated by scootrs the drum hub becomes universal when using the anti dive kit. its just me being picky :anbrgin;

I know it was a big box

My diy scootrs anti-dive

I can't understand why scootRS don't remove the grooved part on the speedo cover on the anti dive kits, as Simon says it just looks wrong and leads to confusion. They take a standard cover, machine grooves for the anti dive bushes and then polish it so they could easily remove the unwanted part while they're at it.
I would tell them but as we already know they don't accept any criticism, constructive or not.

corrado wrote:I can't understand why scootRS don't remove the grooved part on the speedo cover on the anti dive kits, as Simon says it just looks wrong and leads to confusion. They take a standard cover, machine grooves for the anti dive bushes and then polish it so they could easily remove the unwanted part while they're at it.
I would tell them but as we already know they don't accept any criticism, constructive or not.

all sorted now martin, will pop the wheel in later and see how it looks. cheers simon