Scooterotica

diesel wrote:

coaster wrote:I was having a look at my barrel and it looks as if there is shag all meat on it for putting in a boost port,I might get some weld put on in advance of cutting it.How deep does the channel need to be to be effective?

Mine is about 15mm deep at the inlet port end going down to about 8-10mm at the barrel end.

On a purely practicle/sensible level I could have easily bought TS1 kit for what I have spent on my Indian ally barrels over the last 2 years but I wouldn't have learnt as much and I daresay I would still have gone through some pistons and or paid for some dyno time on top

coaster wrote: On a purely practicle/sensible level I could have easily bought TS1 kit for what I have spent on my Indian ally barrels over the last 2 years but I wouldn't have learnt as much and I daresay I would still have gone through some pistons and or paid for some dyno time on top

Sounds like you've almost convinced yourself, mate