Scooterotica

1,light switch
2,Igniton switch
3,Rear brake light switch
4,Head light connector block
Intact anything electrical.

An electric start that's good enough for any Lambretta engine

A proper 70s Snetterton seat.

A proper 70s Snetterton seat.

and a Lambretta Innovation front disc brake set up that fits both tube and tubeless rims

Fireproof cutdowns

Or anything that I can't break

Would it be too much to ask for parts to fit without the need of fettling.




Thought so

red wrote:Would it be too much to ask for parts to fit without the need of fettling.

what everyone should do is send back anything that doesn't fit and demand a replacement that does, or a refund...
trouble is you order the bits in to do a job, then it's quicker to fettle to fit than have to send stuff back and wait around again... i am guilty of that most weeks...

mappable direct fuel injection...ha

Dimitrios_231 wrote:A proper 70s Snetterton seat.

make that x2

As follows :-

Review of the cooling cowling system, especially the head cowl.

Spare petrol tank that can fit neatly onto the battery tray.

Good side stand.

Internal panel plates that can be glued in to stop the panels splitting. I've seen some homemade ones but anyone making them could make a few quid. Nice profiled SS ones.

for Lambretta`s
1/ 5 speed gearbox capable of handling 20+ bhp and has close ratio`s
2/ oil injection
I`ll not hold my breath