Page 2 of 2
Re: GP125
Posted: Wed Feb 16, 2011 9:03 pm
by J1MS
No, that bracket is definately a later addition.
Re: GP125
Posted: Wed Feb 16, 2011 9:04 pm
by jason frost
Ian Hepworth wrote:jason frost wrote:Ian Hepworth wrote:What are you running on the BGM regulator, anything fancy?
Nothing fancy on this one, going to be fitting them as standard now, nice bit of kit.
Good to hear, I suppose the price helps too. Plus if the customer comes back and wants to run something which needs DC you can go "ta da".
Be pulling rabbits out of hats next
Re: GP125
Posted: Wed Feb 16, 2011 9:06 pm
by jason frost
RICSPEED wrote:jason frost wrote:
thought that bracket was particular to 200 electronic frames ....evidently I'm wrong
Just a bit of flat bar welded on I'm not paying for a fixing kit
Re: GP125
Posted: Wed Feb 16, 2011 10:17 pm
by RICSPEED
jason frost wrote:RICSPEED wrote:jason frost wrote:
thought that bracket was particular to 200 electronic frames ....evidently I'm wrong
Just a bit of flat bar welded on I'm not paying for a fixing kit
i see ...a fair bit neater ...i welded captive nuts into the rear support tube