Scooterotica

10 inch Terror wrote:Thanks chaps, i'll do the British thing and join the end of the queue then

Nah get out early and lay ye towel down..

RICSPEED wrote:

Train Driver wrote:Try here http://scooterotica.org/forum/viewtopic.php?f=12&t=8134
nearly 7000 watching this thread so i think a BIG bribe will be needed to jump that queue
if they are all potential buyers

??????????7000 ???????



we don't even have anywhere near that in members

Even less of us at WKFA SC but 5550 kept clicking on to check our rustic retreat thread and in the end only 40 made it over to France.
It was only posted in october for travel the next july, must be the cold dark winter night

nearly 7000 watching

Its not ebay train driver..

7000 is the amount of views the post has had, and this as been very popular indeed, mainly members waiting for updates on either the next batch or to see if the first batch gremlins have been sorted..its 7003 now BTW. Ian H just by way off an update have the gremlins been sorted on the first batch..?

I had one of the first batch and sent it back, my one would show speed at a stand, revs sometime and it was a VERY tight fit into my series 3 Li headset.
The problems are sorted most were caused by us not reading the instructions and earth faults.
Ian is waiting till it ticks over 10000 before sending them out

Lam46 wrote:

nearly 7000 watching

Its not ebay train driver..

7000 is the amount of views the post has had, and this as been very popular indeed, mainly members waiting for updates on either the next batch or to see if the first batch gremlins have been sorted..its 7003 now BTW. Ian H just by way off an update have the gremlins been sorted on the first batch..?

MB have finally got round to testing all the ones that were returned. Only one wouldn't work at all, totally frazzled.
All the others worked fine when wired up properly with a good earth.
We managed to replicate the problems people were having (intermittent working or speedo reading going up and down with revs when stationary) - this occours when the power feed not attached or unit not earthed.

So we are up against the usual male behaviour of "I'll just fit it, I don't need to read the instructions".

We've tweaked the instructions a bit and have changed the wire colours so it's more obvious which is power and which is earth.
2nd batch is ordered and will be about 6 weeks.

send me one of the so called fooked ones then

so am i right in believing i just have to swap
the earth and juice cables over and mine will
be ok

drew2 wrote:so am i right in believing i just have to swap
the earth and juice cables over and mine will
be ok

What colour wires have you got and where are they currently connected?

the wires are black and green,green to
earth and black to live,i am also running
a pitsch r/c that only works on first key
switch (gp) since fitting the mbds