Page 2 of 2
Re: ts1
Posted: Sun Aug 01, 2010 10:52 pm
by flameboy
Lam46 thanks
no both gaskets was sealed had to use a screwdriver to release them both and no blow by signs and very clean too
I leaning towards a sleeve and a piston
Re: ts1
Posted: Mon Aug 02, 2010 12:08 am
by RICSPEED
flameboy wrote: had to use a screwdriver to release them
Re: ts1
Posted: Mon Aug 02, 2010 12:13 am
by Muttley McLadd
RICSPEED wrote:flameboy wrote: had to use a screwdriver to release them
To be fair.. if the engine is still in the frame, there's not really enough room to swing a hammer.
Levering with a big screwdriver is possibly the only other option
Re: ts1
Posted: Mon Aug 02, 2010 1:16 pm
by soosh
I take it the EGT was reading ok then? 600 isnt that hot?
Re: ts1
Posted: Mon Aug 02, 2010 8:57 pm
by flameboy
Yes thats why i didn't notice anything wrong
found the manifold was leaking