Fork clamp bolt
-
- registered user
- Posts: 394
- Joined: Thu Jan 09, 2014 7:34 pm
- Main scooter: li150
- Location: York
- Contact:
Not sure if i have done right or wrong...but I just used an allen bolt with flat and spring washer on mine.
It then gave lots of room to feed in the brake cable.
I dremmeled slightly on the inside of the hole in the headset to take off the sharp edge.
So that it would not cut into the brake cable.
Robbie
It then gave lots of room to feed in the brake cable.
I dremmeled slightly on the inside of the hole in the headset to take off the sharp edge.
So that it would not cut into the brake cable.
Robbie
-
- registered user
- Posts: 394
- Joined: Thu Jan 09, 2014 7:34 pm
- Main scooter: li150
- Location: York
- Contact:
I could not get the cable to pass by the clamp.
You might of already fitted it and had no problems.
So i ground a bit off the clamp. As per photos.
This then gave me room to slide in the cable without removing the clamp in the future.
Again might not be the correct thing to do but its a fairly solid piece of steel so i figured it would not weaken it too much.....famous last words.
Sent from my SM-J415FN using Tapatalk
You might of already fitted it and had no problems.
So i ground a bit off the clamp. As per photos.
This then gave me room to slide in the cable without removing the clamp in the future.
Again might not be the correct thing to do but its a fairly solid piece of steel so i figured it would not weaken it too much.....famous last words.
Sent from my SM-J415FN using Tapatalk