Gearbox shimming - feeler gauges
hi, hope this doesn't sound like a daft question but where abouts should the feeler gauges be placed on the endplate when measuring the endfloat on the large gear shim ? thanks for any info
- ForemanBob
- registered user
- Posts: 224
- Joined: Thu Sep 17, 2009 7:27 pm
- Main scooter: GP RT230
- Location: Isle of Naboombu
- Contact:
The hardened bearing cup that is inserted into the end plate has an L shaped side profile....
you are measuring the gap between the shim and the bottom of the L...
you are measuring the gap between the shim and the bottom of the L...
- garry inglis
- registered user
- Posts: 1298
- Joined: Tue Jul 21, 2015 8:04 pm
- Main scooter: ts1 230 and rb200
- Location: darlington
- Contact:
Here's a picture put the feelers gauge in between the large washer on top off 1st gear and the endplatedb67 wrote:hi, hope this doesn't sound like a daft question but where abouts should the feeler gauges be placed on the endplate when measuring the endfloat on the large gear shim ? thanks for any info
Sent from my SM-A320FL using Tapatalk
- garry inglis
- registered user
- Posts: 1298
- Joined: Tue Jul 21, 2015 8:04 pm
- Main scooter: ts1 230 and rb200
- Location: darlington
- Contact:
Look for 0.30 to0.07
Thanks for the replies guys & the info, plus the brilliant diagram that has definitely made it clearer