Hi all,
Can someone please remind me where I’ve seen the spacer/lifting ring for stators, which allow you to lift the stator for pickup alignment, without having to disturb the pickup itself? I thought that I might have seen these on a SULK thread but cannot now find it. Yes, I am fully aware of the small plates that can be added under the pickup itself, however, those do not serve my requirement/want for quick swaps of stators and flywheels (instant testing of multiple components with less buggering about). Perhaps I am totally wrong about the SULK connection but pointing me in the right direction would be very much appreciated.
Ta
Adam
Stator lifting plates?
-
- registered user
- Posts: 1693
- Joined: Tue Jan 31, 2012 8:54 pm
- Main scooter: Lambretta GP
- Contact:
-
- registered user
- Posts: 1693
- Joined: Tue Jan 31, 2012 8:54 pm
- Main scooter: Lambretta GP
- Contact:
I'll drop Anthony a line to check. Thanks
- HxPaul
- registered user
- Posts: 1110
- Joined: Fri Dec 06, 2013 1:58 pm
- Main scooter: lambretta Li 150
- Location: Halifax,Yorkshire
- Contact:
These are the only stator spacer plates I have found,but there for a Vespa http://www.scooter-center.com/en/produc ... 20mm?meta=
-
- registered user
- Posts: 1693
- Joined: Tue Jan 31, 2012 8:54 pm
- Main scooter: Lambretta GP
- Contact:
I too found those whilst looking, however, these are specific to Lambretta stators and cut to match the profile of the stator's base plate, including the 3 adjustment slots.
-
- registered user
- Posts: 1693
- Joined: Tue Jan 31, 2012 8:54 pm
- Main scooter: Lambretta GP
- Contact:
Well done (and thanks) as Anthony Tambs is the guy producing and supplying these.
Ta
Ta